Grundig 800 Manual do Utilizador

11

FRONT PANEL DESCRIPTION 1. Power - Press this button to turn the unit on or off. 2. Headphone Jack - This connector accepts a 1/8" stereo/mon

13FRONT PANEL DESCRIPTION, cont'd. BEEP - The 'beep' tone is provided to indicate that entries have been accepted or to notify of err

14LCD DISPLAY DESCRIPTION 1. TIMER - This annunciator indicates the state of the Timer as either Active or Inactive. Refer to the 'CLOCK AND TI

15REAR PANEL DESCRIPTION 1. ANTENNA 1 - This connector is used when attaching receiving antennas with coaxial feed lines of 50 Ohm nominal impedance

GETTING STARTED GENERAL OPERATING INFORMATION The SATELLIT 800 MILLENNIUM receiver has been designed for ease of use. Please take a few moments to

17GETTING STARTED, cont'd. SHORTWAVE 'METER' BAND DESIGNATOR ENTRY To facilitate tuning to particular sections of the shortwave band

18GETTING STARTED, cont'd. The synchronous detector will lock to the strongest signal that is within the IF passband when it is activated. Most

19MEMORY FUNCTIONS MEMORY DESCRIPTION The SATELLIT 800 MILLENNIUM contains 70 memory locations that can be used to store and recall commonly monit

20SCAN FUNCTIONS SCAN DESCRIPTION The SATELLIT 800 MILLENNIUM provides a time scan function of programmed memory channels using the button. Scan wil

FRONT PANEL DESCRIPTION (See page 12) LCD DISPLAY DESCRIPTION (See page 14) REAR PANEL DESCRIPTION (See Paee 15)

21CLOCK AND TIMER FUNCTIONS TIME DISPLAY The SATELLIT 800 MILLENNIUM incorporates a dual time clock allowing two 24 hour clocks to be set and maint

CLOCK AND TIMER FUNCTIONS, 22SETTING TIMER ON/OFF TIMES Press and hold the button for approximately 2 seconds until the 'TIMER' annunciat

23CLOCK AND TIMER FUNCTIONS, cont'd.Press Press 'CLR/LOCK' (enters no OFF Time for timer '1') Timers '1' and &a

24CLOCK AND TIMER FUNCTIONS, cont'd.3) Example for Setting Events on Two Different Memory Channels: PROGRAMMING MEMORY 08 in Timer '1&apos

25SPECIAL USE FEATURES AND FUNCTIONS The SATELLIT 800 MILLENNIUM receiver has several special features that are referred to in the main body of this

26QUICK REFERENCE GUIDE The symbol indicates that the button is to be pressed within three seconds. Select normal frequency display (VFO) (page

27QUICK REFERENCE GUIDE, cont'd. Activate (Enabling) Timer (page 22) Press '1' and/or'2' Lock (or Unlock) Controls (page

29 GLOSSARY OF TERMS 1) AC Input - Alternating Current power source available 12) HF - High Frequency band extends from at wall outlet sockets. app

30TROUBLESHOOTING PROBLEM PROBABLE CAUSE SOLUTION No front panel display or light. (A) Power connection. (B) Defective AC ADAPTER unit. (C) Bat

31SERVICE INFORMATION ONE YEAR LIMITED WARRANTYYou may contact GRUNDIG Service Department for additional information or assistance by calling 1

SPECIFICATIONS Frequency Range: 100 to 30.000 kHz (0.1 to 30 MHz). Line Audio Outputs: Stereo left and right. 87 to 108 MHz, 118 to 137 MHz. 3

5 An appliance and cart combination should be moved with care. Quick stops, excessive force and uneven surfaces may cause the appliance and car

TABLE OF CONTENTS Thank you for purchasing the GRUNDIG SATELLIT 800 MILLENNIUM Shortwave Receiver. This receiver has been designed and manufactured

GENERAL DESCRIPTION The SATELLIT 800 MILLENNIUM is a microprocessor controlled, synthesized, world band receiver with con-tinuous coverage capability

POWER SUPPLY AC ADAPTER Keep curtains and other flammable materials out of The SATELLIT 800 MILLENNIUM receiver is supplied direct contact with the A

POWER SUPPLY, cont'd. FIGURE 1: BATTERY INSTALLATION AND REMOVAL BATTERY SUPPLY: 9 VDC 6 X IEC-LR20 OR "D" CELLS DO NOT LEAVE BATTERI

INSTALLATION UNPACKING Carefully remove the SATELLIT 800 MILLENNIUM and included AC ADAPTER from the shipping carton and examine them for evidence of